为研究摇摆耦合升功率条件下一体化自然循环反应堆流动特性,建立自然循环典型三维分析模型,采用计算流体动力学(CFD)方法对摇摆条件下的自然循环进行了数值模拟,并针对不同升功率过程中的的速度和温度分布特性进行分析。结果表明:大幅升功率工况对应的温度和流量存在更为明显的“过冲”现象,摇摆强化了上升传热部件内部壁面换热热通量;在摇摆较为剧烈的条件下,下降段流道存在对于换热器出口冷流体显著的再热作用。
For the study on the flow characteristics of integrated natural ciculation reactor under rolling condition with Rising Power, natural circulation three-dimensional analysis model was established. The natural circulation under rolling condition was stimulated using computational fluid dynamics (CFD) method .The flow and temperature distribution are analyzed for different power raising processes. The results show that there is obvious overshoot phenomenon in the temperature and flow under the condition of large power increase. The heat transfer flux on the inner wall of the upward heat transfer unit is enhanced by rolling. The downdraft passage has a significant reheating effect on the cold fluid at the outlet of the heat exchanger under severe rolling condition.
2023,45(13): 96-99 收稿日期:2022-04-16
DOI:10.3404/j.issn.1672-7649.2023.13.019
分类号:TL333
基金项目:国家自然科学基金资助项目(51306101)
作者简介:廉海波(1974-),男,博士,副教授,研究方向为核科学与技术
参考文献:
[1] STENNING A H, VEZIROGLU T N. Flow oscillations models in forced convection boiling [R]. Proceeding of Heat Transfer and Fluid Mechanics Institute, Stanford University Press, 1965, 301.
[2] LAHEY R T. An assessment of the literature related to LWR instability modes[R]. NUREGCR, 1980: 144.
[3] KAKAÇ S, BON B. A Review of two-phase flow dynamic instabilities in tube boiling system[J]. International journal of heat and mass transfer, 2008, 51: 399–433
[4] FUKUDA K, KOBORL T. Classification of two-phase instability by density wave oscillation model[J]. Journal of Nuclear Society and Technology, 1979, 16(2): 85–108
[5] IAEA. Passive safety systems and natural circulation in water cooled nuclear power plants, IAEA-TECDOC-1624[R]. Austria: International Atomic Energy Agency, 2009.
[6] 张亚军, 王秀珍. 200 MW低温核供热堆研究进展及产业化发展前景[J]. 核动力工程, 2003, 24(2): 180–183
[7] 李卫华, 张亚军, 郭吉林, 等. 一体化核供热堆Ⅱ型的开发及应用前景初步分析[J]. 原子能科学技术, 2009, 43(增刊): 215–218
[8] KIM J H, KIM T W, LEE S M, et al. Study on the natural circulation characteristics of the integral type reactor for vertical and inclined conditions[J]. Nuclear Engineering and Design, 2001, 207: 21–31
[9] CARELLI M D, CONWAY L E, ORIANI L, et al. The design and safety features of the IRIS reactor[J]. Nuclear Engineering and Design, 2004, 230(1–3): 151–167
[10] SHIRVAN K, FORREST E. Design of an organic simplified nuclear reactor[J]. Nuclear Engineering and Technology, 2016, 48(4): 893–905
[11] INGERSOLL D T, HOUGHTON Z J, BROMM R, et al. NuScale small modular reactor for co-generation of electricity and water[J]. Desalination, 2014, 340: 84–93
[12] SERDUN N P, IGNATENKO V I, KOTIKOV G S. Experimental studies into the thermal-hydraulic performance of the VK-300 reactor based on a draft tube model[J]. Nuclear Energy and Technology, 2015, 1(4): 288–295
[13] BAYBAKOV D F, GODOVYKH A V, MARTYNOV I S, et al. The dependence of the nuclide composition of the fuel core loading on multiplying and breeding properties of the KLT-40S nuclear facility[J]. Nuclear Energy and Technology, 2016, 2(3): 183–190
[14] HIBI K, ONO H, KANAGAWA T. Integrated modular water reactor (IMR) design[J]. Nuclear Engineering and Design, 2004, 230(1–3): 253–266
[15] KIM Y S, BAE S W, CHO S, et al. Application of direct passive residual heat removal system to the SMART reactor[J]. Annals of Nuclear Energy, 2016, 89: 56–62
[16] PRIEGO E, ALONSO G, VALLE E, et al. Alternatives of steam extraction for desalination purposes using SMART reactor[J]. Desalination, 2017, 413: 199–216